Specifications: Fluke i430 Flex Current Clamp
| General Specifications | |
| Probe and cable material | TPE rubber, reinforced insulation |
| UL94 V-0, Colour: RED Munsell 7.5 | |
| R 1/14 | |
| Couplings material | Polypropylene, UL94 V-0 |
| Probe cable length | 610 mm |
| Probe cable diameter | 12.4 mm |
| Probe cable bend radius | 40 mm |
| Output cable length | 2.5 meters RG58 |
| Output connector | Safety BNC Connector |
| Operating range | -20 to +90°C |
| Storage temperature | -40 to +105°C |
| Operating humidity | 15% to 85% (non condensing) |
| Degree of protection (Probe) | IP41 |
| Specifications | |
| Current range | 3000 A AC rms |
| Voltage output (@ 1000 A rms, 50 Hz) | 85 mV |
| Accuracy | ±1% of reading |
| (@ 25°C, 50 Hz) | |
| Linearity (10% to 100% of range) | ±0.2% of reading |
| Noise (10 Hz – 7 kHz) | 1.0 mV AC rms |
| Output impedance | 82 Ω min |
| Load impedance | 50 kΩ |
| Internal Resistance per 100 mm probe length | 10.5Ω ±5% |
| Bandwidth (-3dB) | 10 Hz to 7 kHz |
| Phase error (45 – 65 Hz) | ±1° |
| Position sensitivity | ±2% of reading max. |
| Temperature coefficient | ±0.08% max of reading per °C |
| Working voltage (see Safety standards section) | 1000 V AC rms or DC (head) |
| 30 V max. (output) | |
| Safety Specifications | |
| Safety standards | BS EN 61010-1 2001 |
| BS EN 61010-2-032 2002 | |
| BS EN 61010-031 2002, 1000 VRMS, Category III, Pollution Degree 2 | |
| Use of the probe on uninsulated conductors is limited to 1000 V AC rms or DC and frequencies below 1 kHz. | |
| Please note that this probe is designed to work with Fluke 435, if used with other products | |
| Safety rating for the output to earth is limited to 600 V AC rms or DC. | |
Reviews
There are no reviews yet.